First, sorry about my English, and I can't read Russian.

Thanks SAXON13,arcc,Medush. SAXON13 give me lots advice and talk me with English, arcc and Medush published HOWTO with OMAP850 JTAG.

My phone is HTC Touch P3450/Dopod S1, I do everything as HOWTO, but H-JTAG always can't detect target board. I do lots of tests, and I found when I take off the LCD module ( disconnect the LCD module cable), H-JTAG detect target normally.

So I think this phone share some IO between JTAG and display port.

Without LCD, I can see nothing. After load the SPL SAXON13 give to me, my computer found an new USB device, and then install activesync, flash Original full package, then disconnect JTAG and connect the LCD, my phone is back. Then unlock, flash 3.14 unlock and wm6.5 and new radio, etc.

Thanks everybody here, without you, my phone is a brick, thanks.



more picture

Думаю что в отсоеденении диспле не было надобности, я уже замечал что P3450 не хочет с первого раза определяться через H-JTAG, надо после включения девайса и запуска H-JTAG нажать "RESET" на аппарате, и всё нормально определяется...

Thanks, I tried RESET device, but H-JTAG always can't detect target board, maybe I did a wrong way.